How To Install Flat Speaker Cable

Back to the wire run. Here it is about to take a tricky turn, including an outside corner.

I just used the putty knife to help make the turn, wasn’t hard at all. The adhesive on the wire is just right— very sticky, but you can adjust it a little as you go.

Here the run is about 2/3 complete and you can see the flat wire along the baseboard.

I ran the flat wire along this wall to the corner and behind the couch to the middle of the wall on the right side of the photo. Again, this is a good example of how noticeable the flat cable is after installation.

Here’s the end of the line! I trimmed the wire (you can cut it with scissors) and prepared the ends for the termination blocks. The wire comes with good instructions for doing the terminations— you use a razor to separate the copper wire from the white front and adhesive backing.